Freecom ValueLoader, User Manual

Page: 53 / 88

ValueLoader Administration
Configuring the ValueLoader
ValueLoader LTO Tape Autoloader User Manual 39
Circular Mode On/Off
. This option turns Circular Mode on or off,
and is used only in sequential mode. When Circular Mode is on,
the ValueLoader reloads the original first cartridge in the sequence
after cycling through all available cartridges. If Circular Mode is
turned off and the last cartridge has been unloaded, the
ValueLoader stops loading cartridges until you manually load
another cartridge.
To access this option, follow these steps:
1
From the Home Screen or main menu, press the
[+]
or
[-]
button
until “Configuration” appears on the top line of the LCD
screen.
2
Press the
[Enter]
button to select.
3
Press the
[+]
or
[-]
button until “Circular Mode” appears on the
LCD screen. The second line displays the current status of this
mode.
4
Press
[Enter]
to select. The LCD screen indicates whether you
are about to turn Circular Mode on or off.
5
Press the
[Enter]
button to accept the change to Circular Mode
or press
[Cancel]
to exit and not save the changes.
Autoload Mode On/Off
. This option turns Autoload Mode on or off,
and is only used when in Sequential Mode. When Autoload Mode
is on, the ValueLoader automatically loads the cartridge from the
lowest numbered full slot into the tape drive when powered on. It
then follows standard sequential operation as described in
Sequential Mode on page 38.
To access this option, follow these steps:
1
From the Home Screen or main menu, press the
[+]
or
[-]
button
until “Configuration” appears on the top line of the LCD
screen.
2
Press the
[Enter]
button to select.
Caution:
Use caution when choosing Circular Mode as it
makes it possible to overwrite data on previously
written cartridges.