Fortinet AP400 Series, Installation Manual

Page: 65 / 102

Where to Go From Here 51
After the AP433i is connected, check the status of the LEDs. The functions of the LEDs are
described below.
AP433i LED Descriptions
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
1.
From the controller, click Configuration > Devices > AP , and then select the AP.
2.
Select one of these settings for the LED Mode setting:
•
Normal: LEDs are as described above
•
Blink: Sets all LEDs flashing; this is useful to locate an AP
•
Dark: Turns off all LEDs
3.
Click OK .
Where to Go From Here
Now that the AP433i is installed, go to the
Meru System Director Getting Started Guide
for instructions on initializing the hardware. Return to this chapter to check the status
of the LEDs once the WLAN is operational.
LED Function Troubleshooting
Power off—no power
green—presence of power
Status off—no power
green—booting stage 1
blinking green and off—booting stage 2
blinking green and white—discovering
the controller
blinking green and blue—downloading
a configuration from the controller
blinking blue and off—AP is online and
enabled, working state
blinking red and yellow—failure; con-
sult controller for alarm state
If the status LED is blinking red
and yellow, there is an alarm on
the AP. Determine what the alarm
is by clicking
Monitor > Dash-
board > Alarms and looking at the
AP alarms. You can also use the
CLI commands
show alarm and
show log .