Install the AP433e
27
Figure 7:
AP433e Wall Mounting Bracket
1.
Place the mounting bracket against the wall with the sliding lock mechanism facing
upwards. The Quick Reference Installation instructions on the bracket should be visible.
2.
Using the holes on the mounting bracket itself as a guide, mark the location on the wall for
the AP bracket mounting screws. If possible, center the mounting screws on a wall stud.
(If mounting on a wall stud is impossible, use plastic wall anchors on the remaining
screws.)
3.
Drill holes at the locations you marked:
•
3/16-inch holes if you are using plastic anchors
•
1/8-inch holes if you are using only the screws
4.
If you are using plastic anchors, install them in the holes.
5.
Line the bracket up with the holes and screw in the screws.
6.
Attach the mounting screws to the underside of the AP433e in the holes provided (indi-
cated in
).
00270
Summary of Contents for AP400 Series
