Install the AP433e
32
Figure 13:
AP433e Mounted Above a Suspended Ceiling Face Down
5.
Brace your hand against the back of the main support bar and press the AP433e against
the square bracket in a similar manner to that indicated in
.
6.
Twist until the AP433e clicks into place. If desired, you can now lock the AP using the
locking key.
7.
8.
Attach the two legs of the mounting bracket to the T-bars on which the AP is to be
mounted by sliding the clips onto the bars.
9.
For each antenna, loosen the knurled ring at the base of the antenna, point the antenna
down, then retighten the ring (or attach the antennas, if not already done).
10.
Remove a nut from each leg and slide the crossbar (with the AP attached) in place on top
of the legs.
11.
Replace the two nuts, locking the bar in place.
12.
Connect one end of the PoE Ethernet cable to the Ethernet connector.
00263
00271
Mounting Brace
Mounting Bar
Clips attach to T-bar
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be plugged into the
Console port. If you do this. the AP won’t power up.
Summary of Contents for AP400 Series
