Foma F905I, Manual

Page: 48 / 532

46
Voice/Videophone Calls
◆ Adjust Listen volume during a call
<Listen volume>
･
The Listen volume adjusted during a call is reflected to
"Listen volume" of Adjust volume.
1
j
or side keys [ ▲▼ ] during a voice call
･
Volume can be adjusted only by side keys [
▲▼
]
during a videophone call.
◆
Using Voice clear/Voice slowing
❖
Switching Voice clear
Measure the noise level during a voice call, and if the
noise increases above the specified level, the other
party's voice is automatically emphasized to be heard
clearly. And, the volume is automatically increased also
when your or other party's voice is low.
･
This item is set to "ON" by default.
･
This function does not operate while using
Speakerphone function or in overseas GSM/GPRS
network.
･
The settings are retained after a call.
･
This function is not for adjusting Listen volume.
Change the volume of the other party's voice with
Listen volume.
1
During a voice call, m
e
7
If you set Voice clear to ON, appears.
When this does not operate with ON, it is displayed
in gray.
❖
Switching Voice slowing
During a voice call, adjust the other party's voice to be
heard slowly by using the silence at intervals, to make it
easier to be heard. When the other party speaks without
intervals, the voice is heard at the normal speed.
･
This item is set to "OFF" by default.
･
If you set Voice slowing to ON, the quality of the other
party’s voice, music or time tone may change. In such
a case, set Voice slowing to OFF.
･
This function does not operate in overseas GSM/GPRS
network.
･
The settings are canceled after a call.
1
During a call,
a
.
If you set Voice slowing to ON,
appears. When this does not operate with ON, it is
displayed in gray.
Switching voice/videophone call
Call switching can be operated only from the terminal
that has made the voice or videophone call.
･
This function is available among the models which
support switching voice call and videophone call.
･
The voice calls and videophone calls are charged
individually depending on the respective time.
･
To switch the call, Notify switchable mode needs to be
started by the other party. → P64
<Example> Switching to videophone call during a
voice call
1
During a voice call,
t
e
"Yes"
･
During call switching, a message indicating to
switch the call is played.
･
When switched to videophone call, the
speakerphone function is activated.
Switching to voice call during a videophone call :
During a videophone call,
m e 1 e
"Yes"
･
The speakerphone function is canceled when the
call is switched to voice call.
✔
INFORMATION
･
The switching takes approximately 5 seconds. Switching
may take a long time depending on the signal quality.
･
While the switching screen is being displayed, no call cost
is charged.
･
Depending on the signal quality, switching calls is disabled,
resulting in disconnection of the call.
･
During a voice call using Call waiting, switching to a
videophone call is disabled.
･
When packet communications are made during a voice call,
packet communications are disconnected before switching
to a videophone call.
･
While the other party is performing packet communication,
switching to a videophone call is unavailable.
･
The settings such as camera switching, frame selection,
substitute image sending, etc. made during videophone
call are canceled by each switching the voice call and
videophone call. → P62