Copy Data To/From Pump Memory Using the Operator Panel
Step
Action
Result
2
In the Manual pump memory synchronization
fi
eld, select
Copy all from MAS to pump
memory
and click Copy.
“Do you want to perform the
synchronization?” is displayed.
3
Click OK.
“Synchronization OK!” con
fi
rms
when the synchronization is
performed.
Copy Data To/From Pump Memory Using the Operator Panel
Copy All Data
from Pump
Memory to
MAS
At
fi
rst installation, the base unit should be updated with the contents of the pump memory
to upload factory settings of sensors and associated parameters (alarm limits, reset
options, etc.). If any changes are made to the pump memory during service, the new
data should be uploaded to the base unit.
Follow these steps to copy all data from the pump memory to MAS:
Step
Action
Result
1
• Go to General con
fi
g (2.5) in
the Setup menu using up/down
arrow.
• Press OK and use down arrow to
enter menu Pump memory sync
(2.5.6).
2
• Press OK to enter menu Copy all
from PM to MAS (2.5.6.1).
• Press OK to perform
Copy all
from PM to MAS
.
“Execute sync?” is displayed.
3
Press OK to con
fi
rm.
• “Wait” is displayed during the
synchronization
• After synchronization “Sync
executed” is displayed brie
fl
y and
then menu Copy all from PM to
MAS.
• The base unit is now set up
with the selection of sensors
in the actual pump and the
recommended factory alarm
settings.
140
