Flyer Mountain, Original Instruction Manual

Page: 298 / 412

47
EN
Additional information for S-Pedelec EU models
• Legal requirements: Make sure you are fully
aware of the legal requirements that apply to
you . These concern insuring your FLYER, put-
ting it into circulation and using roads and cy-
cle paths in your country . Legal requirements
can vary from country to country . They are
constantly being updated . Please note that you
are not permitted to attach a trailer in which a
child is seated . Child seats are not permitted
either .
• The EU-wide requirements to wear a helmet
and carry a driving licence also apply and may
take a modified form in other countries.
• Replacing parts: Your FLYER is no longer a
bicycle but a motor vehicle . This means that
it requires authorisation . The authorisation is
only valid for the vehicle in its original con-
figuration. Therefore, you must not make any
changes to your vehicle . Only 100% identical
original spare parts may be used . Otherwise,
safe and correct functioning cannot be guar-
anteed . This may lead to accidents or falls that
cause serious injury . The warranty and guaran-
tee will also be rendered void .
• Make sure that the components approved for
an S-Pedelec fit correctly and work properly:
• A rearview mirror, number plate holder and
brake light are required by law . They must be
correctly fastened and must always work prop-
erly . If this is not the case, you may not use
your FLYER S-Pedelec on public roads .
• Light function: For legal reasons, the light
function is always activated as soon as you
turn on the system . The light button has no
function .
• Torque figures: When performing work on
your FLYER S-Pedelec, always comply with
the prescribed tightening torque . You must use
a torque spanner for this . Screws that are too
tight or too loose can cause breakages, faults
or the loss of components .
The requirements to wear a helmet and
carry a driving licence apply to
S-Pedelecs and may take a modified
form in other countries . Please observe
the national laws/regulations on the re-
quired helmet type .
Please note that you are not permitted to
attach a trailer in which a child is seated
to your S-Pedelec . Child seats are not
permitted either .
The rules and regulations for e-bikes are
constantly being revised and changed .
Stay informed about changes in legisla-
tion in order to remain up to date .
Check whether your private third-party
liability insurance covers possible dam-
age caused by using a FLYER e-bike .
8. Type plate and
approval number
8.1 Type plate for pedelecs up to
25 km/h
This chapter explains all the information that is
found on the type plate. The type plate is affixed to
the frame of your FLYER e-bike . There are thirteen
pieces of information on the type plate .
1
13
3
4
5
6
7
8
12
11
10
9
2
1 . CE marking: The CE marking is used by the
manufacturer to declare that the pedelec satis-
fies the applicable requirements.
2 .
Distributor’s contact details:
You can cont-
act the distributor at this address .
3 . Type number: Each type of pedelec has a
unique type number .
4 .
Maximum continuous rated power:
The
maximum continuous rated power is the ma -
ximum power at the output shaft of the electric
motor over a period of 30 minutes .
5 .
Permitted total weight:
The permitted total
weight is the total weight comprising the pe-
delec in its ready-to-use state and its maxi -
mum load (including the weight of the rider) .
6 .
Year of manufacture:
This is the year in
which the pedelec was manufactured .
7 . Bicycle type: See Chapter 8 .3 for more infor-
mation
8 .
Safety information:
See Chapter 8 .2 for more
information