Flyer Mountain, Original Instruction Manual

Page: 289 / 412

38
Loading the battery
The battery can be charged while it is installed in
the e-bike or once it has been removed .
1) Remove the rubber cap
Open the rubber cap on the battery .
Connect the mains plug to a mains socket (220
V - 240 V AC) and connect the charger to the
battery .
Do not connect the charger to the mains
socket immediately after a sudden tem-
perature change from cold to warm . It is
possible that condensed water has col-
lected on the contacts and this will lead
to a short circuit . Do not connect the bat-
tery to the charger immediately after a
sudden temperature change from cold to
warm . Wait until both devices have rea-
ched room temperature before connec-
ting the charger or the battery . Always
charge and store the battery and char-
ger in a dry, covered environment and
only under supervision .
2) Check the LED charge status indicator
Check whether the charge status LED is lit up .
The LED lights up according to the charge status .
The charge status LED goes off when the char -
ging process has been completed .
The charging time takes longer if the
battery temperature is too low or too
high .
A fully charged battery cannot be charged any
further .
The battery may not be recharged when
it indicates a fault . The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
no visible external damage. Such batte -
ries must therefore be inspected by a
FLYER specialist retailer . Never try to
open a battery or to repair it . Damaged
batteries must not be posted .
3) Remove the plug from the power outlet
Separate the mains plug from the mains socket
after disconnecting the battery from the charger .
It is important that the rubber cap is firmly reatta -
ched before using the battery .
Safety warning regarding the battery charger
The name plate refers to warning notes and other
safety information in connection with handling the
charger . It is important to read them before using
the charger .
Please note the temperature ranges of the battery
and charger:
Battery operating temperature: -5 °C to 40 °C
Battery storage temperature: 10 °C to 40 °C
Charging temperature range: 0 °C to 40 °C
Use only the original charger sup -
plied along with your e-bike. Only this
charger is designed for the lithium-ion
battery used on your e-bike .
Completely charge the battery using the
charger before the first ride to ensure full
battery performance . Read and adhere
to the operating instructions for the char-
ger when loading the battery .
The battery can at any time be charged outside
or installed in the bicycle without reducing its life
span . Interrupting the charging process does not
damage the battery .
The battery is equipped with a temperature mo-
nitor that permits charging only within a tempera-
ture range of 0 °C to 40 °C .
Separate the battery from the charger and wait
until it has reached operating temperature . Only
reconnect the charger when it has reached the
permitted operating temperature .