Fluke Calibration 5730A, Operator'S Manual, Page: 168 / 260

5730A
Operators Manual
6-34
Table 6-5. Commands (cont.)
*IDN?
Description
Sequential command.
Returns Calibrator model number and firmware version letters for the main, inguard, and
if attached, the 5725A Amplifier CPU.
Parameter None
Response
(String, string, 0, string)
A message containing four fields separated by commas, as follows:
Fluke
5730A
Serial number
Three firmware versions: one each for the Main CPU, the Inguard CPU, and the Boost
CPU. Each version is separated by a plus (+). If no amplifier is attached then its position
(third character) contains an asterisk (*).
Example FLUKE,5730A,5248000,1.0+B+*
INCR
Description
Overlapped command, ignored if not in remote.
Increments the output amplitude and enters error mode, the same as with the output
adjustment knob in local operation.
Parameter
Increment step size, positive for incremental step, negative for decremental step. Units
(optional) specify magnitude or frequency.
Example
INCR -.00001 Enters error mode and decrements the output by .00001.
INCR 1 Hz Enters error mode and increments the frequency by 1 Hz.
IPADDR
Description
Sequential command. Ignored if not in remote. Sets IP address for LAN communication
when NOT in DHCP mode and with static IP addressing.
Parameter
IP address (quoted string consisting of 4 decimal values bound between 0-255 separated
by periods).
Example
IP "129.196.136.119"
Sets the Ethernet IP static address to 129.196.136.119
IPADDR ?
Description
Sequential command. Returns IP address for LAN communication. When DHCP is
enabled, this address will be the address allocated by the DNS server. When DHCP is
disabled, this address will be the entered value of the static IP address.
Parameter None
Response String
Example
IPADDR?
May return 129.196.137.45 if DHCP is enabled and the DNS server has allocated the
device this address or 129.196.136.119 and DHCP is disabled and the static address
has been previously set to this address.