60
3. Connect one end of the Pump Cable to the
outlet at the lower back of the cabinet.
Tighten the connector ring to secure. (See
Figure 170.)
Figure 170
4. Connect the other end of the Pump Cable to
the round outlet on the other side of the
Module and tighten the connector ring to
secure. (See Figure 171.)
Figure 171
5. Connect the power cord to the port on the
Module. (See Figure 172.)
Figure 172
6. Plug the power cord into an appropriate
outlet.
7. Activate the unit using the power-switch
next to the power cable. (See Figure 173.)
Figure 173
NOTE:
THE ON/OFF SWITCH ON THE
ELECTRONICS BOARD IS NOT FUNCTIONAL
ON THIS MODEL AND HAS NO EFFECT ON
THE OPERATION OF THE UNIT. (See
Figure 174.)
Figure 174
8. The Keypad should confirm power-up by
sounding an audible startup tone and
lighting the LED’s on the Keypad.
Summary of Contents for FB 80M Series
