Flavor Burst FB 80M Series, Manual

Page: 53 / 84

51
Keypad and Keypad Mounting Bracket
Installation
The Keypad is the control unit for the Flavor
Burst system. All normal operating functions
are performed using the Keypad and the
freezer draw handle. The Keypad is attached
to the freezer with the Keypad Mounting
Bracket, which is held in place with adhesive.
1. Slide the Keypad onto the main Bracket
plate and assemble the two Bracket parts in
the style that will best suit your freezer and
daily operations. One example is given in
the figure below. (See Figure 125.)
Figure 125
2. Determine the approximate area and side of
the freezer to attach the Keypad Bracket
that will best suit your needs. Typically this
is the same side as the 9-Tube Assembly so
that the cable can be contained inside the 9-
Tube Assembly Casing. If your freezer
includes an internal switch (see description
in previous section), it is advised the
Keypad assembly, Injector Assembly and 9-
Tube Assembly be installed on the same
side (typically, the left side).
3. Thoroughly clean and dry the face of the
freezer where the Bracket base will be
attached. (See Figure 126.)
Figure 126
4. Remove the protective tape from the
adhesive pad. Attach the Keypad assembly
to the desired mounting area. Ensure there
is enough room between the Keypad
assembly and the freezer face to slide the
Keypad off and on the Bracket. (See
Figure 127.)
Figure 127
5. Fully insert the Keypad stereo plug into the
Spigot Switch jack and ensure that the
connection is fully engaged. (See
Figure 128.)
Figure 128
6. If the freezer has an internal switch, connect
the Keypad stereo plug to the internal
switch jack and ensure the connection is
fully engaged. (See Figure 129.)
26125
Figure 129