Flavor Burst FB 80M Series, Manual

Page: 59 / 84

57
5. Use the bracket thumb screw to adjust the
bracket vertically so that it supports the
Injector Assembly in a level position. (See
Figure 156.)
LEVEL
26084
Figure 156
6. Tighten the thumb nut and thumb screw to
secure the Mounting Bracket.
NOTE: THE MOUNTING BRACKET SHOULD
BE POSITIONED ON THE DRIVE ASSEMBLY
GEAR BOX DURING INITIAL SET-UP AND
DOES NOT NEED TO BE REMOVED DURING
OPENING OR CLOSING PROCEDURES
UNLESS IT REQUIRES A MORE THOROUGH
CLEANING.
7. Locate the 9-Tube Assembly at the lower
back of the cabinet.
8. Fully insert the 9-Tube Assembly into the
Injector Head syrup line opening and rotate it
until motion stops to secure. (See Figure 157.)
26044
Figure 157
Mounting the 9-Tube Assembly Casing
The 9-Tube Assembly Casing should be
mounted on the side of the freezer so that it is
level horizontally. It should be mounted at the
same height as the Injector Assembly so that
the syrup lines are level with the connection at
the Injector Head.
1. Prepare detergent water by mixing
McD
ALL PURPOSE SUPER CONCENTRATE
(APSC) (HCS)
with warm water according
to manufacturer’s instructions.
2. Determine the approximate area where the
Casing will be attached on the side of the
freezer. The Casing should be attached on
the side the 9-Tube Assembly tubes wrap
around to the back of the freezer. It should
also be installed at the same height as the
Injector Assembly and should be level
horizontally.
3. Clean, rinse and dry thoroughly the area
where the Casing will be mounted using
detergent water, clean water, and single
service towels. (See Figure 158.)
Figure 158
4. Remove the protective adhesive tape from
the Casing and mount the Casing to the
desired area on the freezer. (See
Figure 159.)
Figure 159