Flavor Burst FB 80M Series, Manual

Page: 57 / 84

55
4. Spray the 9-Tube Assembly Manifold
opening with McD Sanitizer (HCS) and
allow it to sanitize for at least 5 minutes.
(See Figure 146.)
26068
Figure 146
5. Place the 9-Tube Assembly on a sanitary
tray to dry. (See Figure 147.)
26095
Figure 147
Assembling the Injector Assembly
1. Place the Gear Cartridge into the Drive
Assembly Gear Box so that the gear teeth
line up with the gear inside the Drive
Assembly Gear Box. (See Figure 148.)
Figure 148
2. Install the Injector Head onto the Drive
Assembly Gear Box and rotate off-center to
secure. (See Figure 149.)
26024
Figure 149
3. Insert the Drive Motor into the Drive
Assembly Gear Box so that all four locking
screws are seated properly and rotate the
Motor counter-clockwise to secure. (See
Figure 150.)
26025
Figure 150
Installing the Injector System and Mounting
Bracket
The Mounting Bracket helps stabilize the
Injector Assembly on the freezer. When
properly installed on the freezer, the Bracket
should hold the Injector Assembly level
horizontally, with the Injector Head lined up
directly under the Injector Adapter. The
Mounting Bracket is adjustable to fit many
common freezer models. Additional Mounting
Bracket styles are available for use with other
freezer models. Contact your local distributor
for more information.
The Injector Assembly can be mounted to either
side of the freezer spout. The 9-Tube Assembly
may also come from either side, regardless of
the Injector Assembly’s position. However, on
single freezer models, it is recommended the
Injector Assembly be installed on the opposite
side as the 9-Tube Assembly.