Flavor Burst FB 80M Series, Manual

Page: 31 / 84

29
NOTE: YOUR HANDS SHOULD BE CLEANED
AND SANITIZED BEFORE YOU PERFORM
THE FOLLOWING PROCEDURES.
NOTE: USE THE BRUSHES IN THE
MAINTENANCE KIT FOR THE FOLLOWING
PROCEDURES.
NOTE: USE ONLY MCD ALL PURPOSE
SUPER CONCENTRATE (APSC) (HCS) AND
MCD SANITIZER (HCS) FOR THE
FOLLOWING PROCEDURES.
NOTE: INSPECT ALL WEAR ITEMS AND
REPLACE IF NECESSARY.
Each syrup flavor is stored inside a numbered
tray within the system cabinet. Under normal
operating conditions, flavors are installed as
previous flavors become empty. However, you
may change flavors periodically as desired.
1. Prepare detergent water by mixing
McD
ALL PURPOSE SUPER CONCENTRATE
(APSC) (HCS)
with warm water according
to manufacturer’s instructions. Also prepare
McD Sanitizer (HCS) solution according to
manufacturer’s instructions.
2. Complete “CIP – Phase 2” of the Clean-In-
Place procedure in the SCHEDULED
MAINTENANCE section for the
corresponding syrup line. Do not perform
Step 22.
NOTE:
BE SURE TO PLACE A CONTAINER
UNDER THE INJECTOR HEAD TO CATCH
THE PRODUCT AND SANITIZER SOLUTION.
3. Pull the tray forward and remove the syrup
bag. Discard the syrup bag if it is empty or
expired. If the bag has usable syrup, store
the syrup as directed on the label. (See
Figure 45.)
26190
Figure 45
4. Clean the syrup tray with a single service
towel and detergent water, then rinse and
dry thoroughly using a single service towel.
(See Figure 46.)
Figure 46
5. Select the flavor you wish to use, then place
the bag on the table with the fitment up and
remove the dust cap. (See Figure 47.)
Figure 47
REPLACING THE SYRUP FLAVORS