Flavor Burst FB 80M Series, Manual

Page: 55 / 84

53
6. Thread the 9-Tube Assembly coupler nut
onto the Lead’s casing and tighten to
secure. (See Figure 136.)
Figure 136
7. Return the Cabinet panel to the back of the
unit and secure with the screw. (See
Figure 137.)
Figure 137
Filling the Sanitizer Tank
The Sanitizer Tank system provides approved
sanitizer solution to specific areas of the Flavor
Burst system such as the Injector Head and
Syrup Lines during certain functions. In order
to utilize these clean-in-place functions, keep
an adequate supply of fresh sanitizer solution in
the Sanitizer Tank at all times.
The Sanitizer Tank should be checked on a
daily basis, but only needs to be refilled if the
supply is low.
1. Prepare sanitizing 2 ½ gallons (9.5 Liters) of
McD Sanitizer (HCS) according to
manufacturer’s instructions.
2. Disconnect the sanitizer line by pressing the
lever on the Sanitizer Tank fitment and
pulling the sanitizer supply line free. (See
Figure 138.)
26247
Figure 138
3. Remove the Sanitizer Tank from the
cabinet. (See Figure 139.)
26249
Figure 139
4. Set the Sanitizer Tank upright and remove
the cap. (See Figure 140.)
Figure 140