Flavor Burst FB 80-08, Manual

Page: 53 / 74

52
3. Hang the Suspension Bracket on the lower
door post and install the Injector Assembly
on the preferred side of the freezer. Install
the Injector Head locking ring fully over the
Spout Adapter so that the locking collar
covers the tabs on the Adapter and rotate
the locking collar to secure. (See
Figure 135.)
Figure 135
4. Use the Gear Box thumb nut to adjust the
Suspension Bracket horizontally so that it
hangs straight down from the door nut.
(See Figure 136.)
Figure 136
5. Use the bracket thumb screw to adjust the
bracket vertically so that it supports the
Injector Assembly in a level position. (See
Figure 137.)
Figure 137
6. Tighten the thumb nut and thumb screw to
secure the Suspension Bracket.
NOTE: THE SUSPENSION BRACKET
SHOULD BE POSITIONED ON THE DRIVE
ASSEMBLY GEAR BOX DURING INITIAL
SET-UP AND DOES NOT NEED TO BE
REMOVED DURING OPENING OR CLOSING
PROCEDURES UNLESS IT REQUIRES A
MORE THOROUGH CLEANING.
7. Locate the 9-Tube Assembly at the lower
back of the cabinet.
8. Fully insert the 9-Tube Assembly into the
Injector Head syrup line opening and rotate
it until motion stops to secure. (See
Figure 138.)
Figure 138
Mounting the 9-Tube Assembly Casing
The 9-Tube Assembly Casing should be
mounted on the side of the freezer so that it is
level horizontally. It should be mounted at the
same height as the Injector Assembly so that
the syrup lines are level with the connection at
the Injector Head.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Casing will be attached on the side of the
freezer. The Casing should be attached on
the side that the 9-Tube Assembly tubes
wrap around to the back of the freezer. It
should also be installed at the same height
as the Injector Assembly and should be
level horizontally.