Flavor Burst FB 80-08, Manual

Page: 54 / 74

53
3. Thoroughly clean, rinse and dry the area
where the Casing will be mounted using
detergent water, clean water, and single
service towels. (See Figure 139.)
Figure 139
4. Remove the protective adhesive tape from
the Casing and mount the Casing to the
desired area on the freezer. (See
Figure 140.)
Figure 140
5. Pry open the 9-Tube Assembly Casing.
(See Figure 141.)
Figure 141
6. Place the 9-Tube Assembly, the Keypad
Cable, and the Rotor Cable inside the
Casing. (See Figure 142.)
Figure 142
7. Close the Casing, and press all along the
connection to secure. (See Figure 143.)
Figure 143
Mounting the Accessory Hanging Bracket
The Accessory Hanging Bracket is used to
suspend the Drive Motor and 9-Tube Assembly
while other parts of the system have been
removed for cleaning. The Accessory Hanging
Bracket should be mounted in an accessible
area 6 in. or more above the 9-Tube Assembly
Casing. This will allow enough room for the
Drive Motor to hang properly.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Bracket will be attached on the side of the
freezer. The Bracket should be attached on
the side the 9-Tube Assembly tubes wrap
around to the back of the freezer. It should
also be installed level just below the Keypad
Bracket.