Flavor Burst FB 80-08, Manual

Page: 22 / 74

21
2. Install the Injector Head fully over the Spout
Adapter so that the locking collar covers the
tabs on the Adapter. Rotate the locking
collar to secure. (See Figure 17.)
Figure 17
3. Ensure that the Injector Assembly is level
horizontally and make any adjustments to
the Suspension Bracket as needed using
the adjustment hand knob. (See Figure 18.)
Figure 18
4. Insert the Syrup Line Manifold end fully into
the Injector Head syrup line opening.
Rotate it until motion stops to secure. (See
Figure 19.)
Figure 19
5. With a container under the dispensing
spout, press the ROTOR FLUSH key on the
Keypad to purge any remaining product
from the Injector Head. (See Figure 20.)
Figure 20
Other items to check during opening
procedures
These steps do not necessarily need to be
performed as part of the daily opening
procedures. The following is a list of areas to
check on the Flavor Burst
®
system during
opening procedures. These areas should be
checked and adjusted if necessary.
1. Ensure that the Sanitizer Tank has plenty of
approved sanitizer solution and refill
according to instructions if necessary.
2. Ensure that desired flavors are installed and
that none of the flavor bags are empty.
Replace flavors according to instructions if
necessary.
3. Ensure that the flavor level and the multi-
flavored timing are set to a desired level.
Make adjustments according to instructions
according to the operator’s preference.