Flavor Burst FB 80-08, Manual

Page: 45 / 74

44
Winterizing the Unit
If you will not be using your Flavor Burst
®
system during the off-season or other extended
periods of time, you should winterize the FB 80
system as a precautionary practice to avoid
damage or undesirable syrup build-up in the
unit.
NOTE: YOU DO NOT NEED TO USE
ANTIFREEZE SOLUTION IN THIS SYSTEM
WHEN WINTERIZING THE UNIT.
1. Perform the Clean-In-Place procedure as
instructed, except do not reconnect the
Syrup Bag Adapters or the Connectors to
the syrup bags.
2. Remove each syrup bag from its tray and
store as directed on the label. (See
Figure 103.)
Figure 103
3. Empty all the sanitizer solution from the
Sanitizer Tank. (See Figure 104.)
Figure 104
4. Repeat Steps 15-18 of the Clean-In-Place
Procedure without sanitizer solution in the
tank until the syrup lines are empty of
sanitizer solution. Then perform Steps 20
and 21
.
5. With a container under each Injector Head,
press the ROTOR FLUSH key until the
sanitizer solution is removed from the
sanitizer line. (See Figure 105.)
Figure 105
6. Clean the Injector Assembly and other parts
for off-season storage according to DAILY
CLOSING PROCEDURES and
SCHEDULED MAINTENANCE sections.
(See Figure 106.)
Figure 106
NOTE: DO NOT OPEN OR DISASSEMBLE
THE DRIVE ASSEMBLY GEAR BOX.
7. When opening next season, be sure to
perform the Clean-In-Place procedure again
to sanitize all pumps before recharging the
system with syrups.