73
13.3 MOTOR
To remove the motor:
a)
Disconnect from the electrical power and water supplies.
b)
Feed the drain hose back through the top hole in the drain hose fixture.
c)
Lay the washer on its back on protective material. Ensure that the washer is slightly raised at
the top to prevent residual water in the tub from spilling out.
d)
Remove the base panel by easing the tabs, located at each corner, with long nosed pliers, then
pry the panel off using a flat bladed screwdriver.
e)
Unscrew the rotor using 5/8 “ (16mm) socket and place it in clean plastic bag.
f)
Unscrew the 4 bolts securing the stator using 3/8 “ (10mm) socket.
g)
Remove the stator and unclip the wiring.
