34
9.6 RE-CYCLE FEATURE
WATER LEVEL UP
button turns the
RE-CYCLE
feature on/off.
MEDIUM WATER LEVEL LED ON
- RECYCLE ON
MEDIUM WATER LEVEL LED OFF
- RE-CYCLE OFF (Factory setting).
At the end of servicing, the washer may require an extended test where the washer can be left to
complete a number of wash cycles. By turning on the
RE-CYCLE
feature the washer will
continuously repeat the favourite wash cycle.
When the
RE-CYCLE
feature is turned ON the orange/red wash progress LED’s flash when the
washer is first turned on.
NOTE –
This feature is designed as a service aid only and should be OFF in the customer’s home.
To return to normal operation, and to return the re-cycle feature to the factory setting, switch the
washer off at the wall or disconnect from the electric supply.
9.7 DATA DISPLAYS
It is possible to obtain information about the last fault that occurred in the washer. This information
is stored in the memory, and can be recalled in the DIAGNOSTIC MODE using
DATA
DISPLAYS.
TO SELECT DATA DISPLAYS
1.
Select the
DIAGNOSTIC MODE
by pressing and holding down the
WASH
TEMPERATURE DOWN
button and then pressing the
POWER
button.
2.
The HIGH WATER LEVEL LED will be on. This indicates that you are in
DATA DISPLAY
MODE.
The
SPIN SPEED
buttons and LED’s are used to select the type of data to be displayed. The
WASH PROGRESS LED’s are used to display the data.
High water level LED ON
- DATA DISPLAY MODE
High water level LED OFF
- SWITCH TEST MODE
3.
Press the
SPIN SPEED UP
buttons until the
SPIN SPEED SLOW
LED and
HOLD
LED are
on.
The pattern of the
WASH PROGRESS
LED’s represent a unique fault code. These codes are
explained in more detail in Section 10.2.
If the washer develops a fault the washers Diagnostic system will display these fault codes
automatically.
