38
Action
1.
Check that the drain hose has not been kinked, squashed or blocked in any way.
2.
Check length of drain hose. A 39" (1000mm) extension hose of the same diameter fitted to
the existing drain hose is the maximum allowable length.
3.
If tub empty of water, remove pump from tub via the inspection hatch and check that it is not
blocked.
4.
If tub contains water, attempt to rotate the pump by turning the pump fan. This may clear a
blocked pump. If this does not clear the blockage, then service pump from the top of the
washer by removing the cover and basket.
5.
Check for open circuit windings in the pump. (Note: Pumps are fitted with a thermal cut-out
which will reset on cooling).
6.
Check Pump Harness is connected correctly to pump.
7.
Check continuity of pump harness.
8.
Activate Pump by operating the washer in spin mode. Check Pump is rotating by viewing
through the inspection hatch. If not operating and Primary and Secondary checks have been
performed then replace Motor Control Module.
38. (00100 110) PRESSURE SENSOR FAULT
The Motor Control Module has recorded a water level of empty while it is agitating. The water
level must have been greater than empty for the washer to enter the agitate mode initially.
Action
1.
Check that the pressure tube is connected or has not been cut or damaged.
2.
Replace the Motor Control Module if the pressure tube shows no sign of being faulty.
39. (00100 111) PRESSURE TUBE FAULT
The probable cause of this fault is that the pressure tube has become blocked or kinked or has
fallen off completely. Alternatively the pressure sensor may be faulty.
Action
1.
Check that the pressure tube is intact and not blocked with water, dirt or kinked.
2.
Replace Motor Control Module.
40. (00101 000) BASKET DIS-ENGAGE FAULT
While carrying out a basket check, the Motor Control Module has found that the basket is not
engaged even though the pressure sensor indicates that the tub is empty. The Motor Control
Module continues to check for 2 minutes after which time it displays this fault.
Action
1.
Check that there are no clothes or other foreign objects preventing the clutch from re-
engaging.
2.
If the washer is empty of water carry out a clutch disassembly procedure and check the spline
drive.
