18
6.1 WASH WATER TEMPERATURE
The water temperature of each of the wash temperature settings can be changed.
METHOD OF SETTINGS THE WASH TEMPERATURE
1.
Select the
OPTION ADJUSTMENT MODE
by pressing and holding down the
START/PAUSE
button, then pressing the
POWER
button.
2.
Use
WASH TEMPERATURE
buttons and LED’s to select the temperature setting to be
adjusted, ie. Cold, Cold/Warm, Warm, Warm/Hot, or Hot.
3.
Use the
ADVANCE
button and
WASH PROGRESS
LED’s to increase or decrease the
temperature. Each time the
ADVANCE
button is pressed, the
WASH PROGRESS
LED’s
will advance one position to the right. This increases the temperature by approximately 2oF
(1oC). (See Table 2 for the approximate temperatures for each of the settings).
4.
Select the next temperature range to be changed with the
WASH TEMPERATURE
buttons
and repeat Step 3. Each Temperature range can be adjusted using this method.
5.
To return the washer to Normal operation, press the
POWER
button.
NOTES
1.
Do not use the household water faucets or water heater controls to vary the wash temperature.
The automatic water temperature control system will compensate for variations in household
water temperature and pressure. Adjusting the water pressure or the water heater temperature,
WILL NOT alter the wash temperature.
2.
If the washer is used in an installation where only a cold water supply is available, then the cold
temperature range must be selected and the “cold water only” setting must be chosen in the
Option Adjustment mode. Refer Table 2. A blanking cap must be fitted to the hot inlet valve.
If the temperature is set at any other level, the washer will expect hot water when filling. As it
will not detect any hot water, it will eventually display the USER FAULT (see USER FAULT)
that there is no hot water.
3.
We recommend that the hot water temperature setting on the household water heater does not
exceed 150oF (65oC) for personal safety and washer reliability.
4.
If the temperature of the cold water supply is warmer than the selected temperature, a cold water
user warning will sound because the washer will be unable to control the water temperature to
the required temperature. To correct this re-adjust the cold temperature to cold only setting or a
temperature that is above the cold water supply.
WATER TEMPERATURE SETTINGS
Temperature
Range
15 min
Wash
LED on
12 min
Wash
LED on
9 min
Wash
LED on
6 min
Wash
LED on
3 min
Wash
LED on
Rinse
LED
on
Final
Rinse
LED on
Spin
LED on
Hot
112
114
116
118
120
122
124
126
Warm/Hot
97
99
101
103
105
107
109
111
Warm
87
89
91
93
95
97
99
101
Cold/Warm
77
79
81
83
85
87
89
91
Cold
*F
54
56
58
60
62
64
66
Table 2.
Water Temperature Settings (oF)
*F = Cold water only
