74
h)
To refit motor. Fit wires to stator before locating stator into position. Check wiring is correct.
i)
Grease the stator side of the clamp plates and the inside section of the stator that fits over the
bearing. Fit the clamp plate and spacer assembly to the back of the stator. Ensure the 4 buffers
tubes are in position on the motor shield. Locate the stator, and motor shield onto the tub.
Check that the bearing drain tube is located in the drain hole in the tub and is clipped into place
on the motor shield. It will only fit in one position.
