39
3.
Next check that the pressure tube has not come off and that it is not kinked.
4.
Replace Motor Control Module
41. (00101 001) TEMPERATURE SENSOR FAULT
The temperature sensor is measuring temperatures above 230oF (110oC).
Action
1.
Replace the Motor Controller Module.
43. (00101011) OUT OF BALANCE SWITCH FAULT
The Motor Control Module has found that the signal returning from the out of balance switch
indicates that the switch is permanently on or the harness is disconnected.
Action
1.
Check that the out of balance switch is free to move.
2.
Check switch operates correctly when activated. Replace switch if suspect.
3.
Check the harness to the switch is connected correctly. The terminals should be connected to
the normally closed position.
4.
Replace Motor Control Module.
44. (00101 100) WATER IN TUB DURING SPIN
The Motor Controller has sensed a water level in the tub during spin.
Action
1.
Check that the drain hose is not kinked, squashed or blocked.
2.
Check length of drain hose. A 39" (1000mm) extension hose of the same diameter fitted to
the existing drain hose is the maximum allowable length.
3.
If tub empty of water, remove pump from tub via the inspection hatch and check that it is not
blocked.
4.
If tub contains water, attempt to rotate the pump by turning the pump fan. This may clear a
blocked pump. If this does not clear the blockage, then service pump from the top of the
washer by removing the cover and basket.
5.
Check for open circuit windings in the pump. (
NOTE:
Pumps are fitted with a thermal cut-
out which will reset on cooling).
6.
Replace Motor Control Module.
47. (00101 111) BASKET DIS-ENGAGE FAULT
While carrying out a basket check, the Motor Control Module has found that the basket is not
engaged even though the pressure sensor indicates that the tub is empty. The Motor Control
Module continues to check for 2 minutes. During this time the Module has not been able to
determine a valid basket status and so displays this fault. This fault differs from fault 40 in that a
valid basket status could not be determined.
