32
9.0 DIAGNOSTIC MODE
The washer is fitted with a diagnostic system designed to help the serviceman test the washer and
obtain information that will assist in locating a fault.
TO SELECT DIAGNOSTIC MODE
1.
Press and hold down the
WASH TEMPERATURE DOWN
button, then press the
POWER
button.
9.1 LED TEST
The display will change to
DIAGNOSTIC MODE.
All the LED’s will illuminate for 5 seconds,
then the washer will advance to the
DATA DISPLAY MODE
(High water level LED on ).
Press the
ADVANCE
button to turn the high water level LED off. The washer is now displaying
the
SWITCH TEST MODE
.
9.2 SWITCH TEST
Allows the checking of the lid switch, Out of Balance switch and Location switch. The water
valves and pump can also be switched on during this mode.
9.2.1 LID SWITCH
With the lid closed the 12 minute wash LED should be off. If the lid is open, the 12 minute wash
LED will be on.
9.2.2 OUT OF BALANCE SWITCH
Activating the Out of Balance lever located under the cover will cause the 6 minute Wash LED to
turn on. The Out of Balance lever can be activated by moving the basket assembly towards the
right hand rear corner of the cabinet. It will take up to 1 second for the LED to respond after the
Out of Balance lever has been activated.
