75
j)
Refit the clamp plate onto the stator and tighten the 4 x bolts to a torque of 44 in.-lb. (5 Nm).
Note:
The stator should have some slight radial movement on the resilient mounts of
approximately 1/32 “ – 1/16 “ (0.5 – 1mm) when correctly tightened as shown by arrows on the
diagram below and should have minimal axial play (rocking movement) of 1/32 “ (0.5mm)
maximum.
k)
Fit the wiring harness into the securing clips.
l)
Fit the rotor onto the shaft and located on the spline. Using 5/8 “ (16mm) socket, tighten the
plastic nut to a torque of 140in. –lb. Hold the rotor stationary until it is secured.
Note:
Care should be taken not to catch fingers between the rotor and the stator.
m)
Flatten the base panel tabs. Refit the base panel.
n)
Reconnect the washer, check the agitation and spin cycles.
