FISCHERSCOPE
®
X-RAY
21
Manual Measurements
4
Manual Measurements
Usually the instrument is integrated into production lines. Measurements are performed
automatically, controlled by a superordinate system. Measurement results are sent to the
superordinate system.
But you can also measure manually. This section describes how to perform measure-
ments manually.
To perform measurements you need a product. A product is a file, which contains all
settings for a specific measurement task.
When the instrument is delivered by FISCHER, products that cover your measurement
tasks are usually available. With these products you can perform measurements
immediately.
If you need new measurement tasks, you can request products from FISCHER. The
products are then send to you by email or on a data carrier. Before you can use the new
products, you need to import and calibrate them.
This section describes how to perform measurements.
For further information see the following chapters:
Before you start
The instrument is switched on (see Chap. 3.1 on Page 19).
An appropriate product file is present.
Importing a product
Chap. 7.3 on Page 46
Performing a calibration
Chap. 15 on Page 117
Summary of Contents for FISCHERSCOPE X-RAY 4000 Series
