Fischer Panda Panda 6000i PMS, Manual

Page: 87 / 106

Panda iControl
Panel_iControl_eng.fm Chapter A: Panda iControl - Page 87
Fischer Panda Datasheet
A.5.5 Stop of the generator
1. At higher temperatures (over 25°C) the generator should run 5 min. after the load has been switched off in
order to cool down)
2. Push the „start/stop“ button to switch off the generator.
3. Close additional switches (battry, fuel ect.).
4. Push the „on/off“ button to turn off the iControl“.
A.5.6 Automatic start
The iControl has an „automatic start“ option at clamp RZL and Gnd. Close the connection of these clamps to start
the generator. Open it to stop the generator.
If you use this option make sure that the load is connected to the PMGi after the output has reached the nominal
230V / 50Hz and not to overload the PMGi (some electronic devices - such like air conditions - need an higher
starting current. You may use a relay which connects the load at 230V.
To activate the automatic start:
1. Turn the panel on („on/off“ button)
2. Switch to „Main“ screen („start/stop“ button)
3. Activate automatic start („enter“ button)
To deactivate the automatic start, press the „enter“
button again or switch the panel off with the „on/off“
button
Fig. A.5.6-1: Display automatic start
A.5.7 Additional information
1. The revision of the hard and software is stored in the electronic memory and can be read out by the service
technican.
2. If the iControl is in the stand by mode and the battery voltage drops under 12.1V for more than 2 min., the
iControl shut the system off to prevent the battery for total discharge.