4.0 CONFIGURATION MENU
4-18
CyberCat 254/1016 Programming Manual
Rev 3, 08/2013
P/N: 06-539
4.2.5 HOW TO ENABLE PANEL VOICE OPERATIONS
The “Voice Operation” screen allows you to setup the CyberCat system for voice operation.
From the “Configuration Menu 1” screen, press the F5 key to access the “Voice” screen, as shown below:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
C H A N N E L
M O D E : S I N G L E
B
S E Q U E N C E : S T A N D A R D
C
V O I C E
O U T P U T S : O F F
D
F 1 - M N S
R
F 2 - P R I O R I T Y
Exhibit 4-27: Voice Operations Screen
•
Row A - This field allows you to select whether all system amplifiers will operate in single or dual-
channel mode. Press +/- to change from Single to Dual channel mode. A complete description of
each mode is described as follows.
¾
Single Channel – each amplifier operates independently and is capable of playing a single
audio message in response to a system event.
¾
Dual Channel – two amplifiers are tied together to form a single dual-channel, 50 watt
amplifier with 8 speaker circuits. One amp is dedicated for EVAC operation and the other is
dedicated for Alert operation.
•
Row B – This field allows you to set the city sequence code that will be used by the panel for voice
operation. Press +/- to change select proper city sequence code. A complete description of each
mode is described as follows.
¾
Standard – regular panel operation
¾
Boston – panel will operate following the requirements of the City of Boston.
¾
Chicago – panel will operate following the requirements of the City of Chicago.
¾
New York – panel will operate following the requirements of the City of New York.
¾
Special 1 or 2 – future use
L
Note:
Certain cities require the voice system to operate in a specific manner that differs from the
standard operation of the voice system.
•
Row C – This field allows you to enable Eclipse messages that are unique to voice operation to be
transmitted onto the SLC for the purpose of activating control or relay modules for voice operation.
Press +/- to toggle the field from OFF (default) to ON.
•
Row D – Press the F1 function button to access the mass notification reset screen or press the F2
function button to access the voice state priority screen.
Summary of Contents for CyberCat 10-064
Page 127: ......
