Festo Soft Stop SPC11 Series, System Manual

Page: 96 / 134

4. Commissioning
4-36
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
Manual movement
Manual movement, controlled by a higher-order PLC is poss-
ible in the operating mode “Slave profile 7.4” (see Appendix
A).
Prerequisites: The drive must be ready for operation. There must be a
0-signal at input bits I1...I4. If you are positioning with the
aid of the keyboard, the yellow AS-Interface bus cable must
not be connected.
The moveable mass can be moved manually with the buttons
{
or
}
.
Button Description
{
/- Reduces the position value (the mass moves slowly in
the direction of the measuring system zero point).
+/
}
Increases the position value (the mass moves slowly
away from the measuring system zero point).
In order to move the mass manually:
S
Hold the button
{
or
}
pressed down for as long as is
required to move the mass.
S
Release the button in order to stop the mass.
The position number flashes to indicate that the current posi-
tion can be saved as the intermediate position if the Enter
button is pressed (see section 4.3.3).