Festo Soft Stop SPC11 Series, System Manual

Page: 105 / 134

5. Diagnosis and error treatment
5-5
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
Fault no. Eliminating faults Operating status
Amplification stage, cushioning stage or
system parameter set incorrectly.
S
Correct the parameters
The measuring system has no valid length
code (non-permitted measuring system
length or length code does not exist). Servicing required
SPC11 damaged (EEPROM-ACK fault).
S
Replace the SPC11
Measuring system type is not supported
(invalid measuring system ID read).
S
Replace the measuring system
Communication to Temposonics is faulty
(non-plausible data has been received).
S
Check the measuring system
length or replace the measuring
system.
Communication to Temposonics is faulty
(non-plausible data has been received).
S
Check the measuring system
length or replace the measuring
system.
Incorrect direction of movement ascertained
during positioning stroke; tubing is incor-
rectly connected.
S
Correct the tubing of the propor-
tional directional control valve.
Time out, The position cannot be reached
fast enough (positioning timeout approx.
10 s).
S
Remove obstruction in positioning
path or check compressed air
supply.
Intermediate position does not exist or is
outside the permitted positioning range.
S
Increase the positioning range
and teach the end positions
again, in order that the intermedi-
ate positions lie within the per-
mitted positioning range.
or
S
Teach the intermediate positions
again.