4. Commissioning
4-10
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
Switch-on behaviour after successful pre-commis-
sioning (in the office)
When the operating voltage is switched on again, the SPC11
shows briefly the firmware version number and then one after
the other the values of the three set parameters. The SPC11
then indicates readines to carry out the teach procedure
(t ...). The t flashes (see Fig. 4/2).
Start: Switch-on
behaviour
Display of
system parameters
Display of
amplification stage
Display of
cushioning stage
Wait approx. 1 second
Wait approx. 1 second
Wait approx. 1 second
The SPC11 waits for
the teach task
The t flashes
Firmware version number
Current value
Current value
Display of
firmware version
Wait approx. 0.5 second
Current value
Fig. 4/2: Switch-on behaviour of the SPC11 after
pre-commissioning (in the office)
The teach procedure can be started (see section 4.3.1).
Summary of Contents for Soft Stop SPC11 Series
