4. Commissioning
4-3
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
4.1
General instructions on commissioning
This chapter describes parametrizing and commissioning with
the aid of the three buttons on the SPC11. For commissioning
via the keyboard the AS-Interface cable (bus) must be discon-
nected or without power applied.
If you use slave profile 7.4, you can carry out commissioning
via the AS-Interface bus. Detailed information can be found in
Appendix A.
Warning
During commissioning and during operation the moveable
mass is moved at the highest possible acceleration and
speed. Make sure that:
– nobody can place his/her hand in the positioning range
of the moveable mass, unless the compressed air supply
is switched off.
– the complete positioning range is free of any objects.
Warning
Incorrectly set parameters can damage the fixed stops and
the drive.
Be very careful when setting the parameters.
Summary of Contents for Soft Stop SPC11 Series
