4. Commissioning
4-14
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
4.3
Procedure for commissioning
Warning
Faults in the system structure and incorrect parameters
can cause the slide to move to an end position uncu-
shioned. The fixed stop or the drive may then be damaged.
You must observe the following instructions in order to
prevent such collisions.
– The SPC11 “learns” the location of the end positions
(cylinder end positions or fixed stop positions) by means
of the teach procedure. The teach procedure must be
carried out:
– with the first commissioning
– when the fixed stops have been adjusted
– when components and tubing have been replaced
– when parameters (A, C, S) have been modified.
– During the teach procedure the SPC-11 can recognize
faulty drive tubing or incorrectly set parameters. The
teach process must therefore be carried out again if the
tubing is disconnected and then reconnected, or if the
existing settings are modified.
– Make sure that the maximum permitted mass load is
observed during operation.
Recommendation: Place appropriate warning signs on your
system.
Summary of Contents for Soft Stop SPC11 Series
