Festo CPA VI Series, Manual

Page: 34 / 110

4. Fit the hat rail clamping units onto the end plates of
the CPA valve terminal (see diagram).
5. Hang the CPA valve terminal onto the upper part of
the hat rail (see arrow A).
6. Swing the CPA valve terminal onto the lower part of
the hat rail (see arrow B). Make sure that the clamp-
ing element lies horizontal (parallel) to the hat rail.
7. Secure the CPA valve terminal against tipping or
sliding by tightening the screws on both sides with
1.3 Nm
1
2
3
Hat rail
Clamping element of the hat rail clamping unit
Self-cutting M4x10 screw of the hat rail
clamping unit
Fig. 2/2: Fitting the CPA valve terminal onto a hat rail
B
2
1
A
3
2. Fitting
2-6
CPA... 9808A