Festo CPA-SC Series, Manual

Page: 114 / 140

5. Maintenance and conversion
5−12
Festo P.BE−CPASC−EN en 0808c
Fitting
1. Insert the fastening pin (in Fig.5/2 position
5
) for posi
tioning the separator element into the appropriate hole of
channel (1), (3) or (5). The relevant holes are marked in
black in the example (Fig.5/3) in VP 4.
2. Place the separator element (in Fig.5/4, position
1
) on
the hexagon socket screw.
3. Align the recess in the separator element (in Fig.5/4,
position
2
) flush with the fastening pin.
4. Push the separator element on the right−hand side of the
base block into the appropriate channel (1), (3) or (5) until
it touches the fastening pin (see Fig.5/4).
1
Recesses in the
separator element
2
Separator
elements
1
2
Fig.5/4: Fitting pressure zone separator elements
5. Pull the fastening pin by the projecting dismantling aid
out of the hole (in the example in VP 4).
6. Insert the fastening pin into the hole of the appropriate
channel on the next valve location. The relevant holes are
marked in black in example (Fig.5/3) in VP 5.
7. Tighten the separator element with 0.8 Nm +20 %.