2. Fitting
2−11
Festo P.BE−CPASC−EN en 0808c
2.3
CPA−SC individual location base block
The CPA−SC individual location base block should be mounted
on a wall if it is to be incorporated in a system or a machine.
Proceed as follows:
1. Make sure that the fastening surface can support the
CPA−SC individual location base block (weights see
appendix A, Tab.A/3).
Make sure there is sufficient space for connecting the supply
cables and tubing.
2. Drill four mounting holes in the fastening surface
(distance between holes see Fig.2/4).
1
Holes for horizontal fastening
Holes for vertical fastening
15,3
41
6,8
10
+
49.3
0,1
+
2.8
0,1
1
1
1
Mounting holes
Fig.2/4:
CPA−SC individual location base block: position of and distance between the
mounting holes
3. Fasten the CPA−SC individual location base block to the
fastening surface with two M3 screws of sufficient length
(tightening torque 1 Nm).
Summary of Contents for CPA-SC Series
