Festo CPA-SC Series, Manual

Page: 120 / 140

A. Technical appendix
A−4
Festo P.BE−CPASC−EN en 0808c
Severity
level Vibration Shock Continuous shock
1 0.15 mm travel at 10
Ū
58 Hz
2 g accelerat. at 58
Ū
150 Hz
±15 g at 11 ms duration
5 shocks per direction ±15 g at 6ms duration
1000 shocks per direction
2 0.35 mm travel at 10
Ū
60 Hz
5 g accelerat. at 60
Ū
150 Hz
±30 g at 11 ms duration
5 shocks per direction −−−−−
Tab.A/2: Values for vibration and shock as per DIN/IEC 68
General information Approximate weights
Weights
Valve terminal CPA−SC:
Weight of basic unit CPA−SC valve terminal:
with MP/FL connection
with HC/PI connection
with DI connection
Additional manifold block weight per valve position
Per valve sub−base
Per blanking plate
Individual location valve CPA−SC:
Base block with valve sub−base
250 g
100 g
500 g
40 g
50 g
6 g
200 g
Tab.A/3: Weights
Caution
Operate the CPA−SC valve terminal only with the medium
described below:
If possible, use non−lubricated pilot air (connections
12/14). Otherwise note the instructions in chapter 3,
section Preparing the compressed air".
In the case of CPA valve terminals with internally
branched pilot air, the above−mentioned instruction also
applies to the supply air (connection 1).