Festo CP Factory, Original Operating Instructions

Page: 69 / 90

Operation
© Festo Didactic 8065842 en
69
5. Application is selected to setup the application module. The corresponding actuators can be started by
pressing the buttons. The sensors are only for display and cannot be set manually
Position Description
1
Move X-axis
Button extend: move X-axis to pick up position (actor PH_MB1 is activated, lights up blue if active)
PH_BG1: Sensor PH_BG1 (lights up green when X-axis in pick up position)
PH_BG2: Sensor PH_BG2 (lights up green when X-axis in back position)
2
Move Z-axis
Button lift: move Z-axis upwards (actor PH_MB3 is activated, lights up blue if active)
PH_BG3: Sensor PH_BG3 (lights up green when Z-axis in upper end position)
3
Move Z-axis
Button lower: move Z-axis downwards (actor PH_MB is activated, lights up blue if active)
PH_BG4: Sensor PH_BG4 (lights up green when Z-axis in lower end position)
4
Switch on vacuum
switch on button: switch on vacuum (actor PH_MB6 is activated, lights up blue if active)
5
Switch on blowing air
switch on button: switch on blowing air (actor PH_MB7 is activated, lights up blue if active)
PH_BG6: Switch PH_BG6 display (lights up green when vacuum is on and label is sucked)
6
Switch on cutter motor
switch on button: switch on cutter motor (actor PH_MB8 is activated, lights up blue if active)
Cut label (optional order at label printer)