Festo CP Factory, Original Operating Instructions

Page: 49 / 90

Commissioning
© Festo Didactic 8065842 en
49
D-Sub-interface for analogue signals (option – not available at all application modules)
The CP application module produces a analogue output signal. These is put on the analogue terminal (4)
and must be connected with the analogue inputs of the basic module:
•
Connect the analogue terminal (4) of the CP application module with the D-Sub-interface for analogue
signals (6) on the rear board of the basic module CP Lab Conveyor. Therefore use the provided
connecting cable (1) with standard D-Sub plugs: 15-pin, two-rowed.
Electrical connections / illustration similar
Position Description
1 connecting cable with15-pin standard D-Sub-plugs
2 basic module CP Lab Conveyor: control or decentralized periphery
3 CP application module: I/O terminal (+BG-XD1)
4 CP application module: analogue terminal (+BG-XD2A)
5 connecting cable with a SysLink-plug (SysLink-cable)
6 basic module CP Lab Conveyor: board at the back (+G1-XZ2)