Festo CP Factory, Original Operating Instructions

Page: 15 / 90

Fundamental safety instructions
© Festo Didactic 8065842 en
15
CAUTION
•
Setting up pneumatic circuits
– Connect the devices with plastic tubing with an outside diameter of 4 or 6 mm.
– Push the pneumatic tubing into the push-in connector as far as it will go.
•
Dismantling pneumatic circuits
– Switch off the compressed air supply before dismantling the circuit.
– Press the blue release ring down so that the tubing can be pulled out.
•
Noise due to escaping compressed air
– Noise caused by escaping compressed air may damage your hearing. Reduce
noise by using mufflers, or wear hearing protection if the noise cannot be
avoided.
– All of the exhaust ports on the components included in the equipment set are
equipped with mufflers. Do not remove these mufflers.