Festo CP Factory, Original Operating Instructions

Page: 65 / 90

Commissioning
© Festo Didactic 8065842 en
65
Pressure regulators are used for regulating the air pressure for the axles and the vacuum for the vacuum
sucker.
Requirements
– Pneumatic port of the cylinders and vacuum has been made.
– Compressed air supply is switched on.
Procedure vacuum
1. At first, turn off the pressure regulator completely. Then turn it on again and adjust it to approx. 1 bar.
To secure the screw, tighten the knurled screw to lock it.
2. Start a test run, the workpiece shouldn´t fall off.
Procedure axles
1. At first, turn off the pressure regulator completely. Then turn it on again and adjust it to approx. 2 bar.
To secure the screw, tighten the knurled screw to lock it.
2. Start a test run, it should be possible to stop the axes by hand easily.
Documents
•
Data sheets
Pressure regulator 8086004 (VRPA-CM-Q6-E)