Ferrari California, Workshop Manual

Page: 655 / 1727

Fastening the upper front arm to the hub carrier Nut (pretightening) 52 Nm A
Nut 52 Nm A
Fastening upper arm to chassis Nut (pretightening) 25 Nm A
Nut 60 Nm A
Fastening shock absorber to chassis Screw (pretightening) 10 Nm A
Screw 30 Nm A
Fastening shock absorbers to chassis (FROM
Assembly No. 103179)
Screw (pretightening) 20 Nm A
Screw 110 Nm A
Tightening torque Nm Class
The replacement arm is supplied complete with Flanbloc and ball joint.
The following procedure is for refitting the right hand front suspension upper arm.
The procedure for refitting the left hand front suspension upper arm is the same.
Clean any traces of grease from the ball stud.
Fit the washers on the relative stub bolts and fit
the upper front suspension arm (B) in its
relative seat.
Apply the nut (3) , after installing the relative
washer, and pretighten.
Tightening torque Nm Class
Nut (pretightening) 52 Nm A
Loosen the nut (3) and then tighten.
Tightening torque Nm Class
Nut 52 Nm A