Ferrari California, Workshop Manual

Page: 590 / 1727

Check that the calliper mating surfaces with the
stub axle are clean, fit the brake calliper (A)
to the disc and tighten the two screws (2) .
Tightening torque Nm Class
Screw 100 Nm A
Fit the rigid pipe on the brake calliper, tightening
the union (1) .
Tightening torque Nm Class
Union 15.5 Nm B
Refit the front brake pads ( D3.04 ).
Fill and bleed the brake system ( D3.10 ).
Refit the wheels ( D2.01 ).
Removing the rear brake calliper
Hydraulic brake fluid is corrosive.
Contact with brake fluid may cause severe injury or damage to painted parts of the vehicle.
In the event of skin contact with fluid, wash the respective part of the body immediately with plenty of
water.
In the event of contact between the fluid and painted parts of the vehicle, wash and dry the respective
areas immediately.
Remove the wheels ( D2.01 ).
Remove the rear brake pads ( D3.04 ).
Undo the union (1) for the flexible hose on the
calliper.
Undo the two screws (2) fastening the calliper
(A) .
Remove the calliper from the rear suspension.
Refitting the rear brake calliper