Ferrari California, Workshop Manual

Page: 1428 / 1727

Each time the battery is connected to the electrical system of the vehicle, WAIT 1 MINUTE before
inserting the key in the ignition switch and do not switch on any current consumers during this
period.
After inserting the ignition key, turn to "II" and WAIT AT LEAST 1 MINUTE before starting the engine.
This procedure ensures that the ECUs in the vehicle are powered up and synchronised correctly, that
all motorised valve aperture and closure travel parameters are self-acquired correctly and that AC
ECU self-acquisition is performed correctly.
These self-acquisition procedures are initiated each time the battery is connected to the vehicle.
Connect the quick release clamp to the negative
battery pole.
Fasten the quick release clamp on the negative
pole of the battery using the lever (A) .
For vehicles with Stop&Start system
Connect the quick release clamp to the false
negative battery pole.
Fasten the quick release clamp on the false
negative pole of the battery using the lever
(A) .
Refit the engine compartment cosmetic shields ( E3.13 ).
Refit the right hand lateral cosmetic shield.
Before starting the engine again, perform the following operations: close the doors, the engine
compartment lid and the luggage compartment lid, unlock and lock the doors with the remote control,
open the luggage compartment lid with the remote control, set the date and time on the instrument
panel, close the doors, raise the door windows and rear quarterlights to the upper limit and check that
the windows drop to the target position when the doors are opened.
If this procedure is not followed correctly, the buttons in the passenger compartment for opening the
luggage compartment lid, locking/unlocking the doors and releasing the fuel filler flap will be
disabled.
Restore the self-adaptive parameters ( F2.01 ).
Restoring the self-adaptive parameters