FBII XL-4, Programming Manual

Page: 54 / 100

XL-4, XL-4B, and XL-5 LCD Keypad Programming Manual Version 4
8–32
burglary zones that have been defined with lockout enabled. Dialer lockout does not effect
the bell activation. Default = 15 (None).
If multiplex capability is present then the global lockout counter will be used to determine
the number of individual point supervision faults that will lock out the dialer. Default = 15
(None).
If you do not want global dialer lockout enter 15.
UL
For UL Listed systems this option shall be programmed "15".
Local Dialer Lockout Counter
082 LOC DIAL LK
15 (00-15)
Indicates the number of dialer activations from an individual zone that will cause a dialer
lockout. This counter will be reset with each arming of the system and applies only to
burglary zones that have been defined with lockout enabled.
If multiplex capability is present then the local lockout counter will be used to determine the
number of bus supervision faults that will lock out the dialer. Default = 15 (None).
If you do not want local dialer lockout enter 15.
UL
For UL Listed systems this option shall be programmed "15".
System Function Codes
The System Function Codes section defines the codes (0-9, A-F) that will be transmitted to
the Central Station when various conditions occur. The values A-F can be entered into any of
these questions as follows:
DIGIT KEYSTROKES OR
A SHIFT 1
✴
1
B SHIFT 2
✴
2
C SHIFT 3
✴
3
D SHIFT 4
✴
4
E SHIFT 5
✴
5
F SHIFT 6
✴
6
The SHIFT key is the
✴
(asterisk) key as shown on the programming overlay.
Enable Zone Tamper
083 EN ZONE TAMP
NO
This option determines whether the system will have a tamper zone for each zone. When
enabled, all even zones will report tamper in the partition that the previous odd zone is