68
Revision date: 12.02.16
TWIST-OF-THE-WRIST ASSEMBLY
Gather the parts:
Aluminum channel (102570) and drive handle
(102480)
Gearbox (103496) and gearbox drive (102717)
Mounting plate (103544), bearing (102569), and
threaded rod (FAK26)
3/8" nuts (FALB04B) and 3/8" washers (FAME08B)
The Twist-of-the-Wrist Assembly is designed to roll up the
side panel. The following steps describe the assembly
and its installation. Sample frame is shown.
1. Measure 1/2" in from the end of the roll-up conduit,
center-punch the location on the pipe, and drill a 5/16"
hole through the conduit.
1/2"
2. Insert a tubing
adapter into the
conduit and align
the holes of the
adapter with the
drilled holes in
the conduit.
2"
4. Position the channel along the end rafter where the
Twist-of-the-Wrist assembly will be located.
5. Secure upper end of the channel by drilling a 3/8"
hole through end rafter and attach as shown. Lower
end of channel will "float" and is not attached.
3. Select the aluminum channel, drill a 3/8" hole through
the channel approximately 2" from the end, and attach
a threaded rod using a 3/8" nut on each side of the
102570 channel.
End Rafter
Threaded
Rod
(FAK26)
111613Z144
Ground Post
or Rafter Leg
Gear Box
(103496)
Guide
Channel
(102570)
Carriage
Bolt
Roll-Up Side
Conduit
Baseboard
Do not allow channel to contact ground. Use position of
roll-up conduit, which is at the base of frame along the
side, to help align channel when securing it in place.
Top View
End
Rafter
Roll-Up Side Panel Installation
