31
Revision date: 12.02.16
Install Ridge Vent
Install the ridge vent framing before the roof film is installed. Consult the technical documents at the back of these
instructions to get a general understanding of how the vent is assembled. Photos below show a few ridge vent details.
Photo shows inside view of ridge vent as
seen from the ground looking up. Install vent
cables at each end of the ridge vent only.
Use the cables to square the vent frame on
the building frame. Tighten until cables are
snug.
Consult the ridge vent technical documents
for additional cable installation details.
Photo shows a sample building with an
installed ridge vent in the open position.
IMPORTANT:
When attaching the slam rail
to the end rafters, do not install where vent
opening is located. See dashed line above.
Attach the 104546 rail to the top of
the end rafters
after
installing the
fabric end panels if equipped.
Rail is
included with the building.
Do not install 104546 rail
here at each end.