84
Revision date: 12.02.16
Black-out System Installation
ATTACH PANEL FIXATION COMPONENTS
1. Using FA4482B Tek screws, attach the 102197
spring channel as shown to all headers except
end black-out header #2. Spring channel will
follow the contour of the header tubes and
continue down the outside edge of the vertical
header as shown below.
IMPORTANT:
102197 spring channel is to be
attached over the top of the installed 113323
monofilament wire clips.
If clips have not been
installed at this point, reference page 124 and
install BEFORE attaching the spring channel.
2. Where the horizontal header meets the vertical
header, cut spring channel to fit, leaving 1" to 2"
of space between. Bottom of the vertical spring
channel sections to be level with the bottom of
the vertical header profile tube.
3. File sharp edges of spring channel where cut.
Consult diagrams below and technical documents at
the back of these instructions for location details.
IMPORTANT:
Orientation of the 102197 spring
channel is critical. Use side view diagram to the
right to determine orientation. Verify that the open
channel of the 102197 spring channel is facing
towards the end wall header with the 113694 wire
brackets attached.
End
Black-Out
Header #1
End
Black-Out
Header #2
CUT-AWAY
SIDE VIEW
Mid-Rafter
Headers
102197
Spring Channel